Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 277)

Survey Pro Reference Manual
R-120
1/2 Road Width : displays the width of the selected road section
defined in the previous screen. This value can quickly be edited from
this field.
HR : is the rod height.
%DFNVLJKW« : accesses the Backsight Setup screen (Page R-72).
%DFN : returns to the previous screen.
6ROYH ! : accesses the next screen.
Offset Staking – Screen Four
The fourth Offset Staking screen displays the information needed to
aim the total station toward the selected design point.
Station : displays the current station and section
of the roadway being staked and the current line
segment type from the polyline that describes the
centerline. If staking the center and an offset
was specified,
(To L) or (To R) is also displayed to
indicate if the offset is to the left or right of the
centerline, respectively.
Offset : displays the offset that is applied to the
design point.
Slope : displays the slope of the road at the
section being staked.
From Gun to Design Point : displays the angle and distance
information from the total station to the design point (plus offset if
specified).
&LUFOH =HUR : is used to modify the circle on the total station so that
the angle right reading will be zero when it is facing the current
target, which can sometimes be easier than turning to an obscure
angle value. When this button is tapped, the following actions will
occur:
1. A new backsight circle value is computed, sent to the instrument
and stored in the raw data