Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 66)

User’s Manual
60
Set Up
1. Open the job that was created in the Traverse / Side Shot
Example if it is not already open.
a. From the Main Menu, select
)LOH , 2SHQ  1HZ to open the
Open / New screen.
b. Tap the file name that was created
earlier listed in the Open Recent Job list
and then tap
 2SHQ . The coordinates for
that job are shown here.
2. Set the job settings. (Only the settings that
affect this example are covered here.)
a. Select
-RE , 6HWWLQJV from the Main
Menu.
b. Select the Instrument Settings screen and
set both the Brand and Model fields to
Manual Mode .
c. Select the Surveying Settings screen and confirm that all of
the checkboxes are unchecked.
d. Select the Stakeout Settings screen and make sure the Cut
Sheet Offset Stored field (at the bottom of the screen) is set to
Actual Offset .
Note: When performing stakeout, you have the option of storing cut
sheet information. This information is stored in the raw data file,
and when using software on a PC, such as Survey Link, it can be
extracted in the form of a Cut Sheet Report.
e. Tap
2. to save the job settings.
3. Setup your backsight. In this example, we will setup on Point 1
and backsight an object with a known azimuth. When connected
to a total station, you would setup over your occupy point, aim
toward the backsight and zero the horizontal angle in the total
station before continuing.