Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 213)

Survey Pro Reference Manual
R-56
LOT# were used as in the screen shown above, all entries of
“LOT10” would be connected. If LOT15 were also used as a
description during data collection, any future use of LOT15
would connect to the previous LOT15 entry.
Note: Linework descriptions are case sensitive.
Cmd : lists the current type of line segment (linework) that will be
created after shooting the required points and storing them with the
associated
Description . The following linework command options are
selected by repeatedly tapping the appropriate button:
• /LQH : creates a straight line between the next two points
stored with a description associated with Line .
• 3&UY : creates a curve through the next 3 points stored
with a description associated with P-Crv .
• 5&UY : creates a curve between the
next two points that are stored with a
description associated with
R-Crv . After
the second R-Crv point is shot, the
prompt shown will open and is used to
define the details of the curve.
• 7&UY : creates a curve with a specified
incoming tangent from the next two
points that are stored with a description
associated with
T-Crv . When the second
point is stored, the prompt shown here
appears where the incoming azimuth or
bearing is specified.