Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 202)

Job Menu
R-45
(GLW« : Accesses the third screen, described next, where the current
polyline can be modified.
&OHDU : removes the current polyline.
Screen Three – Polyline Editor
Once the initial points are selected for the current polyline, the third
screen allows you to modify the polyline and define any curve and
grade information for the polyline sections.
Selecting any point in the left column of the
screen will select that point and the line
segment that follows it up to the next point.
The selected section is then highlighted in the
map portion of the screen. Any edits will occur
on the selected section.
5HPRYH : will remove the selected point and
the line segment that follows it. The previous
line segment will be automatically joined to the
following point. The change will only be saved
if you then tap
2.. Tapping &DQFHO will return
to the previous screen without saving the changes.
&OHDU $OO : will completely remove the current polyline. The change
will only be saved if you then tap
2.. Tapping &DQFHO will return to
the previous screen without saving the changes.
&XUYHV« : Accesses the fourth screen, described below, where a
horizontal, vertical, or spiral curve can be added to the selected
polyline segment.
Horizontal / Vertical : toggles between showing the map in a
Horizontal (overhead) view or a Vertical (side) view.
 ,QVHUW : allows you to insert a point, or a group of points in front of
the selected point. The change will only be saved if you then tap
2..
Tapping
&DQFHO will return to the previous screen without saving the
changes.