Table c.2 411-ud connections to facp – Fire-Lite MS-9600LSC Addressable Fire Alarm Control Panel User Manual
Page 189
MS-9600LS Series Manual — P/N 52646:B2 2/12/2010
189
NFPA Standard-Specific Requirements
The following figure illustrates an example of Central Station/Remote Station Reporting using a
411UD. The relay contacts from the FACP may be used to trip any dialer UL listed for Central
Station/Remote Station Reporting Services.
Figure C.2 FACP Connection to 411UD
Note: The Monitor Module input, which is being used to monitor
the 411UD Relay #2 Output (programmed for DACT Trouble),
must be programmed as ‘Trouble’ at FACP.
Channel1
Channel 2
Channel 3
Channel 4 (2.2K ELR)
Relay Output (DACT Trouble)
Monitor Module ELR resistor
FACP
Supervisory Relay
FACP
Alarm Relay
(2.2K ELRs
P/N 27070)
J4 Not Installed
411UD
Monitor Module Circuit Input
SLC Loop
+ -
FACP
960
04
11
u.w
m
f
24 VDC
nonresettable
power
1 2 3 4 5 6
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
9
1 2 3
Monitor Module*
FACP
Trouble Relay
*If the SLC device does
not match the one in this
figure, refer to the SLC
manual appendix, which
contains wiring conversion
charts for type V and type
H modules.
411UD
FACP
Alarm
TB2-1
TB1-1
TB2-2
TB1-3
Trouble
TB2-3
TB5-2
TB2-4
TB5-3
Supervisory
TB2-5
TB5-4
TB2-6
TB5-6
Table C.2 411-UD Connections to FACP