West Control Solutions MRC 9000 - Manual (Page 164)

Section 4 Edition 3
Rev G 4-82
DERIVED ACTUATOR
1
Selections
1 to 24
Press the to change, then to
desired number, then press the .
17. Press the and the display advances to INSTRUMENT TAG. To exit, press the . Refer to the
beginning of this section, page 4-72.
4.1.13 DERIVED ACTUATORS
Derived Actuators are used when two or more actuators need to be combined logically.
From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASSWORD
appears in the lower display line, the correct "password" will need to be entered before access to Configuration is
allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9, En-
ables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the , then the until DERIVED ACTUATORS appears in
the lower display line.
1. Press the to display DERIVED ACTUATOR.