West Control Solutions MRC 9000 - Manual (Page 274)

Section 14 Edition 3
Rev G 14-6
DA4 DA5 DA6
DA7 DA8 DA9
DA10 DA11 DA12
DA13 DA14 DA15
DA16 DA17 DA18
DA19 DA20 DA21
DA22 DA23 DA24
OUTPUT_11 OUTPUT_12
OUTPUT_21 OUTPUT_22
OUTPUT_31 OUTPUT_32
OUTPUT_41 OUTPUT_42
EVENT 1 EVENT 2
EVENT 3 EVENT 4
EVENT 5 EVENT 6
EVENT 7 EVENT 8
PRESET_1 PRESET_2
PRESET_3 PRESET_4
TOTAL_PO1 TOTAL_PO2
TOTAL_PO3 TOTAL_PO4
TIME_1 TIME/DATE_1
TIME_2 TIME/DATE_2
TIME_1_TO_TIME_2
TIME/DATE_1_TO_2
TIMER_1 TIMER_2
TIMER_3 TIMER_4
SW1 SW2 SW3 SW4
SW5 SW6 SW7 SW8
COMM_TRIGGER_1
COMM_TRIGGER_2
COMM_TRIGGER_3
COMM_TRIGGER_4
F1 F2 F3 F4 F5
RESET MOD ENTER
ON_THE_HOUR
ON_THE_WEEK
DAY_OF_MONTH
RELAY_1 RELAY_2
RELAY_3 RELAY_4
RELAY_5 RELAY_6
RELAY_7 RELAY_8
CA1F1 CA1F2 CA1C3
CA1F4 CA1F5
CA2F1 CA2F2 CA2C3
CA2F4 CA2F5
CA3F1 CA3F2 CA3C3
CA3F4 CA3F5
CA4F1 CA4F2 CA4C3
CA4F4 CA4F5
POWER_FAILED
PROFILE_ACTIVE
PROFILE_COMPLETE
PROFILE_ABORTED
PROFILE_HOLDING
PROFILE_AUTO_HOLDING
PROFILE_OFF/CONTROL
PROFILE ACTIVE is true whenever a profile is
running or holding; not aborted or com-
plete. PROFILE COMPLETE is true when a
profile has run to completion. PROFILE
ABORTED is true whenever a profile has
been aborted. PROFILE HOLDING and (time
not advancing) and PROFILE AUTO HOLD-
ING (holding due to deviation hold after
ramping) are self explanatory.
The PROFILE OFF/CONTROL actuator is
controlled by the END ACTION, ABORT
ACTION, and POWERFAIL ACTION choices,
whenever a profile completes, is aborted, or
power fails, respectively. When this capabil-
ity is desired, the PROFILE OFF/CONTROL
actuator must be selected for the CONTROL
ON ACTUATOR, which is lcated in the Instru-
ment Settings section.