West Control Solutions MRC 9000 - Manual (Page 267)

Section 13 Edition 3
Rev G 13-36
10.Press the to advance to the next parameter, OUTPUT 1 AUTO RESET (only if output 1 is proportional).
Cx OUT 1 AUTO RESET
0.00 REPEATS/MIN
Selections
0 to 100.00
11.Press the to advance to the next parameter, OUTPUT 2 AUTO RESET (only if output 2 is proportional).
Cx OUT 2 AUTO RESET
0.00 REPEATS/MIN
Selections
0 to 100.00
AUTO RESET (Integration) compensates for process load variations which cause the process value to deviate
from setpoint. Integration will occur over the range defined by the INTEGRATION BAND. The value is defined in
repeats per minute.
Press the to change, then or
to desired number, then press the .
Press the to change, then or
to desired number, then press the .