West Control Solutions MRC 9000 - Manual (Page 189)

Edition 3
Rev G 5-4 Section 5
6. Following the top level Manual Values prompts, the "Standard Display" prompts are displayed as follows:
DISPLAY MODE
CONTINUOUS SEQUENCE AMM used, default CONTINUOUS
DISPLAY FORMAT
1 VAL 2 VALS 4 VALS AMM used, default 1 VAL
SEQUENTIAL DISPLAY
DURATION n SECONDS SEQUENCE, AMM used, default 1
7. If any OPERATOR INPUTS (OIs) are configured and visible, they appear in numerical order following the
above prompts. The prompts are as follows:
pppppppppppppppppppp programmable prompt text
nnnnnnnnnnyyyyyyyyyy AMM used, see below
The second line is a choice list with two items, the "n" item being the programmable OFF STATE TEXT phrase
associated with the OI, and the "y" item being the programmable ON STATE TEXT.
An OI is configured when its prompt text as Configured in OPERATOR INPUTS section of CONFIGURATION, is
not blank. It is visible when the following conditions apply:
WHEN DISPLAYED (prompt in OPERATOR INPUTS) configured to always
or
if configured to ENABLED in ENABLES & PASSWORDS.