West Control Solutions MRC 9000 - Manual (Page 262)

Edition 3
Rev G
Section 13 13-31
13.4 TUNING PARAMETERS
The Tuning parameters section is where adjustments to the proportional band, automatic reset (integral), and other
parameters for proper operation of proportional controls and/or first output/second output etc. for on/off controls are
made.
For illustration purposes, all available parameters have been listed. The parameters that will appear on the specific
instrument will depend upon the parameters previously selected in CONTROLLERS section.
To enter TUNING PARAMETERS, from the Normal Display, press the key until TUNING PARAMETERS is
seen in the lower display line. If PASSWORD appears in the lower display line, the correct “password” will need to
be entered before access to TUNING PARAMETERS is allowed. If TUNING PARAMETERS is not displayed, then
Tuning Parmeters has been disabled. Refer to Section 9, Enables and Passwords, for instructions to enable Tuning
Parameters.
With TUNING PARAMETERS in the lower display line:
1. Press the key to display CONTROLLER NUMBER.
CONTROLLER NUMBER
1
Selections
1-4
Press the to change, then or
to desired controller number, then press the .