West Control Solutions MRC 9000 - Manual (Page 218)

Edition 3
Rev G
Section 10 10-1
Section 10 - Test
Test describes all possible diagnostic tests built into the recorder.
From the Normal Display, depress the until TESTS appears in the lower display line. If PASSWORD
appears in the lower display line, the correct "password" will need to be entered before access to Test is allowed.
If TESTS is not displayed, then Test has been disabled. Refer to Section 9, Enables and Passwords, for instruc-
tions to enable Test.
A list of available tests and their purpose are shown in Table 10-1.
TABLE 10-1 AVAILABLE TEST
Relays Used to verify that all LEDs, Relays and/or Solid State Relay Drivers (SSRD) are
working correctly.
Display Used to verify the display is functional.
Keypad Used to verify that all keys are functional.
LEDs Used to verify that the functionality of the LEDs.
Chart Demonstration Used to demonstrate chart capabilites.
CAUTION: When this test is iniitated, any parameter values previously
programmed in Chart Configuration and Recorders are replaced with the
demonstration values.
A/D Reset Counter Displays the number of times the A/D counter has been reset.
FACTORY USE ONLY!
A/D Raw Hex Counts Displays raw counts for inputs and grounds. FACTORY USE ONLY!
Calibrated Input Values Displays calibrated input values for inputs and grounds. FACTORY USE ONLY!
mA Output Used to verify the mA Output is functional.