West Control Solutions MRC 9000 - Manual (Page 203)

Edition 3
Rev G
Section 7 7-3
5. Press the to advance to the next parameter, ALARM 4 SETPOINT. If RATE Alarm was selected,
setpoint refers to RATE.
6. Press the and the display advances to the next applicable ALARMS FOR PV NUMBER prompt. Refer to
the beginning of this section, page 7-1.
Units correspond to
Units configured in
Process Variables with
per unit time included if
a rate of change alarm
is specified.
* Decimal position
configured in Process
Variables.
Press the to change, then to
desired value, then press the .
Ax4 SETPOINT
100 units
Selections
±
999999
(*decimal position = 0)
±
9.9999
(*decimal position = 4)