West Control Solutions MRC 9000 - Manual (Page 275)

Edition 3
Rev G
Section 14 14-7
14.3 PROFILE CONTROL
To enter the Profile Control section, from the Normal Display, press the DISP key until SELECT appears in the
upper display line and PROFILE CONTROL appears in the lower display line. If PROFILE CONTROL is not
displayed, then Profile Control has been disabled. Refer to Section 9, Enables and Passwords, for instructions to
enable Profile Control.
1. With PROFILE CONTROL displayed, press the DOWN key and START PROFILE will be displayed.
Selections are PROF 1 through PROF 16 and CONTROL ON. To change, press the MOD key, then UP/
DOWN as required to desired choice, then press the ENTER key.
Start Profile - The profile to start can be derived from the result of the PROFILE START actuator
positive transition (See PROFILE START ACTUATOR in PROFILE SETTINGS) that takes the
value of the PROFILE SELECTOR value or the START PROFILE NUMBER entered above. Only
available if profile is not already running.
2. Press the SCROLL key to advance to the next parameter, START DESCRIPTION. This is a READ
ONLY parameter.
Start Description - Start description corresponds to the PROFILE DESCRIPTION under the
PROFILE ENTRY menu for the selected profile.
3. Press the SCROLL key to advance to the next parameter, PROFILE START/STOP. Displayed in
Automatic Modify Mode, AMM, selections are ABORT/STOP or RUN/START. Press the key directly
below the choice to enter.
4. Press the SCROLL key to advance to the next parameter, PROFILE RUN/HOLD (only seen if RUN/
START selected above). Displayed in AMM, selections are RUN or HOLD. Press the key directly below
the choice to enter.
Profile Run/Hold - A profile put into HOLD will stop the ramp or dwell segment currently running.
If the profiler is in HOLD no action is taken. If RUN is selected, a profile in HOLD will resume
from the current profile, segment and time selected. If the profiler is in RUN when RUN is
selected, no action is taken.
5. Press the SCROLL key to advance to the next parameter, CURRENT PROFILE.
Selections are 1 to 16. Press the MOD key to change, then press the UP/DOWN as required to desired
choice, then press the ENTER key.
Current Profile - If a profile is not running, this parameter can be modified to change the current
active profile. When RUN is selected under PROFILE RUN/HOLD, the profiler will begin running
the current profile selected.
6. Press the SCROLL key to advance to the next parameter, CURRENT DESCRIPTION. This is a READ
ONLY parameter.
Current Description - The current description corresponds to the profile description entered under
PROFILE ENTRY.