Cx out 1 hysteresis 3 units, Cx out 2 hysteresis 3 units, Cx out 1 percent upper limit 100 – West Control Solutions MRC 9000 User Manual
Page 237
Section 13
Edition 3
Rev G
13-6
6. Press the
to advance to the next parameter, OUTPUT 1 HYSTERESIS
(only seen if OUT 1 TYPE is ON/OFF).
NOTE: Units correspond to
Units configured in Process
Variables
Cx OUT 1 HYSTERESIS
3 UNITS
Selections
0 to 999999
(decimal position = 0)
0 to 9.9999
(decimal position = 4)
7. Press the
to advance to the next parameter, OUTPUT 2 HYSTERESIS (only seen if OUT 2 TYPE is ON/
OFF).
NOTE: Units correspond to
Units configured in Process
Variables
Cx OUT 2 HYSTERESIS
3 UNITS
Selections
0 to 999999
(decimal position = 0)
0 to 9.9999
(decimal position = 4)
8. Press the
to advance to the next parameter, OUTPUT 1 PERCENT UPPER LIMIT (only seen if OUT 1
TYPE is PID).
Cx OUT 1 PERCENT
UPPER LIMIT 100%
Selections
1 to100
Press the
to change, then
or
to desired number, then press the
.
Note: Hysteresis centers on the control setpoint.
Press the
to change, then
or
to desired choice, then press the
.
Press the
to change, then
or
to desired number, then press the
.
Note: Hysteresis centers on the control setpoint.