Spx prompt text setpoint 1, Spx display units ° f, Spx other units ° f – West Control Solutions MRC 9000 User Manual
Page 250
Edition 3
Rev G
Section 13
13-19
2. Press the
to advance to the next parameter, PROMPT TEXT.
SPx PROMPT TEXT
SETPOINT 1
Selections
TEXT
Note: If PROMPT TEXT is blank, the corresponding setpoint will not be activated or appear in the prompts associ-
ated with the
key. Also, no other prompts are displayed for configuring the setpoint.
3. Press the
to advance to the next parameter, DISPLAY UNITS.
SPx DISPLAY UNITS
°
F
Selections
°
C
°
F OTHER
4. If DISPLAY UNITS selected was OTHER, press the
to advance to the next parameter, OTHER UNITS.
SPx OTHER UNITS
°
F
Selections
TEXT
Press the
to change, then
to desired
choice, then press the
, or press the key directly
below the desired choice.
Refer to Section 3.4.2, Changing Text, for instructions.
Refer to Section 3.4.2, Changing Text, for instructions.