West Control Solutions MRC 9000 - Manual (Page 188)

Edition 3
Rev G
Section 5 5-3
To change the setpoint, press the key, then keys to desired setpoint, then press the
key.
To exit, press the key.
5. Following the top level Setpoint Prompt, if any controllers are configured for PID control and are in manual
mode, the following prompt will appear:
SELECT
MANUAL VALUES
This prompt provides an alternative method of manually changing controller outputs. When this prompt is dis-
played, pressing the key will display the following:
Cx OUTPUT 1 visible if output 1 proportional
MANUAL OUTPUT nnn% value 0-100, initially current value
Cx OUTPUT 2 visible if output 2 proportional
MANUAL OUTPUT nnn% value 0-100, initially current value
These prompts are displayed for each controller in manual mode, where x is the controller number, 1-4.
To change, press the key, then keys to desired setting, then press the key.
To exit, press the key.