West Control Solutions MRC 9000 - Manual (Page 165)

Edition 3
Rev G
Section 4 4-83
2. Press the to advance to the next parameter, COPY/INITIALIZE.
Choose YES if the parameters to be programmed are the same as another DERIVED ACTUATOR already
programmed.
If selection was NO, proceed to step 3.
If selection was YES:
D
E
R
I
V
E
D
A
C
T
U
A
T
O
R
S
Press the to change, then to
desired choice, then press the .
DAxx COPY / INITIALIZE
NO
Selections
NO YES
DAxx COPY FROM DA
(0 = INITIALIZE) XX
Derived Actuator to be copied from
0 = FACTORY DEFAULT
Press the to change to the desired
actuator to be copied from.