West Control Solutions MRC 9000 - Manual (Page 310)

Edition 3
Rev G
Appendix C C-15
ZONE 1 LOW - System Prompts - Configuration - Recorders - Page 4-47
Parameter that specifies the DIVISION or ring corresponding to the “bottom” end of the zone.
For reverse ranges (lower engineering value at the outer portion), either the two ZONE parameters or the two
SPAN parameters can be reversed.
ZONE 2 HIGH - System Prompts - Configuration - Recorders - Page 4-49
Parameter that specifies the DIVISION or ring corresponding to the “top” end of the second zone. Setting it to
zero specifies that only one zone is being used. ZONE 1 HIGH specifies the “bottom” of zone 2 if two zones are
used.