Operator message 1, Omxx copy / initialize no – West Control Solutions MRC 9000 User Manual
Page 171
Edition 3
Rev G
Section 4
4-89
4.1.15 OPERATOR MESSAGES
Operator Messages are user defined messages to advise or provide information, via the display, that selected
actuators are active.
From the Normal Display, press the
until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to
Configurat allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section
9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the ,
then the
until OPERATOR MESSAGES appears
in the lower display line.
1. Press the
to display OPERATOR MESSAGE.
2. Press the
to advance to the next parameter, COPY/INITIALIZE.
Choose YES if the parameters to be programmed are the same as another OPERATOR MESSAGE already
programmed.
OPERATOR MESSAGE
1
Selections
1 to 12
Press the
to change, then
to
desired number, then press the
.
Press the
to change, then
to
desired choice, then press the
.
OMxx COPY / INITIALIZE
NO
Selections
NO YES
O
P
E
R
A
T
O
R
M
E
S
S
A
G
E
S