West Control Solutions MRC 9000 - Manual (Page 276)

Section 14 Edition 3
Rev G 14-8
7. Press the SCROLL key to advance to the next parameter, CURRENT SEGMENT. Selections are 1-8.
Press the MOD key to change, then the UP/DOWN as required to the desired choice, then press the
ENTER key. Only modifiable if profile is presently not running.
Current Segment - This is the current active segment, which can be modified if the profile is not
active. When RUN is selected under PROFILE RUN/HOLD the profiler will begin running from
the current profile and the new current segment entered.
8. Press the SCROLL key to advance to the next parameter, RAMP TIME REMAINING. Only modifiable
if profile is presently not running.
9. Press the SCROLL key to advance to the next parameter, DWELL TIME REMAINING. Only modifiable
if profile is presently not running.
Ramp/Dwell Time Remaining - These parameters may be modified if the profile is not active.
When RUN is selected under PROFILE RUN/HOLD, the profiler will begin running from the
current profile, current segment using the new RAMP and/or DWELL time. If the profile is active
and updating the ramp or dwell time the value displayed when first entering the menu will be the
last value read.
10. Press the SCROLL key to advance to the next parameter, EVENT OUTPUTS. Under each event
number is the current state, 0 or 1. Selections are “0” or “1”; “0” is not active and “1” is active.
Event Outputs - Event Outputs can always be modified. Event outputs represent the current
active segment ramp or dwell.
11. Press the SCROLL key to advance to the next parameter, PROFILE STATUS ACTION (only seen if
profile has been aborted). Displayed in AMM, selections are ABORTED or CONTINUE. Press the key
directly below the choice to desired.
Profile Status/Action - If a profile has been aborted the profile can be continued using the choice
CONTINUE.
12. Press the SCROLL key and the display returns back to START PROFILE.