West Control Solutions MRC 9000 - Manual (Page 248)

Edition 3
Rev G
Section 13 13-17
26.Press the to advance to the next parameter, DISPLAY RAMPED SETPOINT.
Cx DISPLAY RAMPED SP
NOT DISPLAYED
Selections
NOT DISPLAYED
IN CONTINOUS MODE
IN SEQUENTIAL MODE
IN BOTH MODES
27.Press the to advance to the next parameter, DISPLAY % OUTPUTS (only if either output is propor-
tional).
Cx DISPLAY % OUTPUTS
NOT DISPLAYED
Selections
NOT DISPLAYED
IN CONTINOUS MODE
IN SEQUENTIAL MODE
IN BOTH MODES
28. Press the and the display advances to the next controller to be programmed. Refer to the beginning of
this section, page 13-3.
Press the to change,then , to
desired choice, then press the .
Press the to change,then , to
desired choice, then press the .