West Control Solutions MRC 9000 - Manual (Page 263)

Section 13 Edition 3
Rev G 13-32
2. Press the to advance to the next parameter, COPY/INITIALIZE.
Cx COPY/INITIALIZE
NO
Selections
YES or NO
If selection is NO, see Step 3.
If selection is YES:
Cx COPY FROM CONTRLR
(0=INITIALIZE) X
Input to be copied from
0=FACTORY DEFAULT
3. Press the to advance to the next parameter, SETPOINT RAMP RATE.
Cx SP RAMP RATE
0 units/HR
Note: Units correspond to Units
configured in Process Variables.
Selections
0 to 999999
(decimal position=0)
0 to 9.9999
(decimal position=4)
RAMP RATE dampens the rate at which the control algorithm will ramp to the control setpoint. If the setpoint
changes abruptly from one value to another, an internal setpoint will be ramping to the selected setpoint (SP1,
SP2, or Remote) at the rate selected in Cx SP RAMP RATE. The internal setpoint is viewable by setting the
ramped setpoint parameter, Cx DISPLAY RAMPED SP located in CONTROLLERS section to something other
than NOT DISPLAYED.
Press the to change, then or
to desired selection, then press the .
Press the or to the control number to be
copied from
Press the to change, then or
to desired number, then press the .