West Control Solutions MRC 9000 - Manual (Page 273)

Edition 3
Rev G
Section 14 14-5
7. Press the SCROLL key to advance to the next parameter, PROFILE DISPLAY OPTION. Selections
are: NOT DISPLAYED; IN CONTINUOUS MODE; IN SEQUENTIAL MODE; or IN BOTH MODES. Press
the MOD key to change, then UP/DOWN to desired choice, then press the ENTER key.
If one of the DISPLAY option is selected, the parameters displayed are as follows:
START PROFILE number
description
CURRENT PROFILE number
description
status
status
CURRENT SEGMENT
NUMBER number
RAMP TIME hhh:mm:ss
DWELL hhh:mm:ss
EVENT 12345678
OUTPUTS ssssssss
setpoint description (may be up to four and only if configured to be displayed in
setpoint value SETPOINT Configuration.)
status - The top display line displays whether the profile is RUNNING, HOLDING, or AUTO
HOLDING. The bottom display line displays if the profile is RAMPING or in DWELL.
8. Press the SCROLL key and the display advances back to the beginning of Profile Settings.
ACTUATOR LIST
NONE/OFF
ON/CONTINUOUS
ANY_ALARM
ANY_PROCESS_ALARM
A11 A12 A13 A14
A21 A22 A23 A24
A31 A32 A33 A34
A41 A42 A43 A44
INSTRUMENT_ALARM
CHART_FULL
OP_INP_1 OP_INP_2
OP_INP_3 OP_INP_4
OP_INP_5 OP_INP_6
OP_INP_7 OP_INP_8
OP_INP_9 OP_INP_10
OP_INP_11 OP_INP_12
CHART_CHANGED
CHART_ROTATION
TREND_DATA_COLLECT
DA1 DA2 DA3
When Profiling is included in an instrument,
several actuators are added to the choice
list as indicated in bold in the list below.