Rockwell Automation 1333 Drive, 3/4-5HP, 230-575V Series D - Manual (Page 3)

Summary of Changes
Summary of Changes
Summary of Manual Changes
This release of the 1333-5.2 User Manual contains some new and corrected
information. The new and corrected information is summarized in the table
below. For further information, refer to the page numbers provided.
Description of New or Corrected Information Page Type
Drive Input Terminals 4Ć8 Correction
Recommended Wire Size and Torque 4Ć15 Correction
SW2 Factory Setting -- Figure 4Ć5 4Ć20 New
Terms 6 & 3 Analog Meter Output
Meter Load Impedance 4Ć22 Correction
Terms 13 & 14 -- S1/4SP
Terms 13 & 14 -- S2/4SP
SW2 Factory Setting 4Ć24 New
Parameter 02 -- Deceleration Time 1
From 00.01Ć1000 seconds . . . sets the decel time . . .
5Ć9 Correction
From 1000Ć1600 seconds . . . sets the decel time . . . 5Ć9 Correction
Local/Remote Control Enable
If set to 0 . . .
w Local Jog can be selected by . . . the Shift button . 5Ć14 Correction
If set to 2. . .
w Local Jog can be selected by . . . the Shift button . 5Ć15 Correction
1. SW2 Factory Setting 5Ć24 New
As shown in Figure 4Ć5 in Chapter 4
If Parameter 19 = 0
When Control Board Switch SW2 is Set to . . . 5Ć25 Correction
If Parameter 19 = 1
When Control Board Switch SW2 is Set to . . . 5Ć25 Correction
If Parameter 19 = 2
When Control Board Switch SW2 is Set to . . . 5Ć25 Correction
As shown in Figure 4Ć5 in Chapter 4
If Parameter 19 = 0 and Parameter 20 = 0
When Control Board Switch SW2 is Set to . . . 5Ć26 Correction
If Parameter 19 = 1 and Parameter 20 = 0
When Control Board Switch SW2 is Set to . . . 5Ć26 Correction
If Parameter 19 = 2 and Parameter 20 = 0
When Control Board Switch SW2 is Set to . . . 5Ć26 Correction
As shown in Figure 4Ć5 in Chapter 4
If Parameter 19 = 0 and Parameter 20 = 1
When Control Board Switch SW2 is Set to . . . 5Ć27 Correction
If Parameter 19 = 1 and Parameter 20 = 1
When Control Board Switch SW2 is Set to . . . 5Ć27 Correction
If Parameter 19 = 2 and Parameter 20 = 1
When Control Board Switch SW2 is Set to . . . 5Ć27 Correction
Preset Frequency Settings
Auxiliary Accel and Decel Settings 5Ć34 Correction