Control and signal wiring, Terminal block – Rockwell Automation 1333 Drive, 3/4-5HP, 230-575V Series D User Manual
Page 35
Installation and Wiring
Chapter 4
4-18
Control and Signal Wiring
The Control and Signal Wiring Terminal Block is located at the bottom of
Terminal Block
the Control Board. The Control and Signal Wiring Terminal Block is a
twenty-four position terminal block with markings of 1 to 24. The drive is
capable of operating from the Local Control and Programming Panel
without any external control or signal connections provided the factory
installed jumper at terminals 16 and 17 is installed. When required,
external operator elements may be connected to provide remote control of
the drive. Several additional drive control functions and status outputs are
also available for use at this terminal block.
Drive Control and Signal Wiring Terminal Block
Drive Ground Terminals
Drive Control Board Switches
SW2
SW1
Figure 4Ć3 -- 3/4Ć5ĂHP (.55Ć4ĂkW) Control and Signal Wiring Terminal Block