Rockwell Automation 1333 Drive, 3/4-5HP, 230-575V Series D - Manual (Page 9)

Pre-Installation Care
Chapter 1
1-2
!
ATTENTION: This assembly contains parts and sub-assemblies
that are sensitive to electrostatic discharge. Static control
precautions are required when servicing this assembly. Component
damage may result if you ignore electrostatic discharge control
procedures. If you are not familiar with static control procedures,
reference Allen-Bradley Publication 8000-4.5.2, Guarding Against
Electrostatic Damage, or any other applicable ESD protection
handbook.
Electrostatic Discharge
Electrostatic discharge generated by static electricity can damage the
Precautions
complimentary metallic oxide semiconductor devices on various drive
boards. It is recommended that you perform these procedures to guard
against this type of damage when circuit boards are removed or installed:
•
Wear a wrist type grounding strap that is grounded to the drive chassis.
•
Attach the wrist strap before removing the new circuit board from the
conductive packet.
•
Remove boards from the drive and immediately insert them into their
conductive packets.