Span your clamp and ejector valves chapter 9, Command and status blocks used – Rockwell Automation 1771-QDC, D17716.5.87(Passport) CLAMP AND EJECT MODE User Manual
Page 138
Span Your Clamp and Ejector Valves
Chapter 9
9-2
Command and Status Blocks Used
The following table contains a list of command blocks you are to configure
throughout the course of this chapter. You may reference these command
blocks in sections 1 and 3 of the Plastic Molding Module Reference
Manual (pub. no. 1771-6.5.88).
Block:
Type:
Used in this Chapter to:
ProĆSet 600 Files:
System (SYS)
Status
View Programming Errors
View Clamp Position
View Ejector Position
B35, N41
Clamp Close Profile (CPC)
Command
Enter Clamp Close Profile Values
B37, N43
Clamp Open Profile (OPC)
Command
Enter Clamp Open Profile Values
B37, N43
Ejector Profile (EPC)
Command
Enter Ejector Profile Values
B39, N45
Dynamic Command Block
(DYC)
Command
Initiate Profile Execution
B37, N43
First Clamp Close (FCC)
Command
Enter First Clamp Close Values
B37, N43
Second Clamp Close (SCC)
Command
Enter Second Clamp Close Values
B37, N43
Third Clamp Close (TCC)
Command
Enter Third Clamp Close Values
B37, N43
Clamp Low Press Close (LPC)
Command
Enter Clamp Low Press Close Values B37, N43
First Clamp Open (FOC)
Command
Enter First Clamp Open Values
B37, N43
Second Clamp Open (SOC)
Command
Enter Second Clamp Open Values
B37, N43
Third Clamp Open (TOC)
Command
Enter Third Clamp Open Values
B37, N43
Clamp Open Slow (OSC)
Command
Enter Clamp Open Slow Values
B37, N43
Ejector Advance (EAC)
Command
Enter Ejector Advance Values
B39, N45
Ejector Retract (ERC)
Command
Enter Ejector Retract Values
B39, N45
ATTENTION: As with any machine start-up, make sure a test
mold is installed in the machine. Programming errors,
configuration errors, or hydraulic problems could lead to
machine damage or injury to personnel.
ATTENTION: Make sure all machine guards and shields are in
place before proceeding.