Use configuration command block worksheets – Rockwell Automation 1771-QDC, D17716.5.87(Passport) CLAMP AND EJECT MODE User Manual
Page 78
Load Initial Configuration Values
Chapter 7
7-2
This chapter walks you through a configuration procedure that helps you
fill out all of the following configuration block worksheets. Worksheets
for each of the command blocks are given followed by the information to
fill them in later in this chapter.
Configure Clamp and Eject Blocks
Ten different blocks need to be configured before you are ready to enter
profile setpoint values in chapter 8. Worksheets to configure each of these
blocks are given later in this chapter. These blocks and worksheets are:
Clamp Close
1.
First Clamp Close (FCC)
2.
Second Clamp Close (SCC)
3.
Third Clamp Close (TCC)
4.
Low Pressure Close (LPC)
Clamp Open
1.
First Clamp Open (FOC)
2.
Second Clamp Open (SOC)
3.
Third Clamp Open (TOC)
4.
Clamp Open Slow (OSC)
Ejectors
1.
Ejector Advance (EAC)
2.
Ejector Retract (ERC)
Use Configuration
Command Block
Worksheets