Rockwell Automation 1771-QDC, D17716.5.87(Passport) CLAMP AND EJECT MODE - Manual (Page 73)

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-6
Table 6.I
Status Bits for Clamp and Eject Mode
Category: Bit Status
(when = 1):
QDC Block
Addr.:
ProĆSet
Addr.:
Jog Status unassigned # 1 jog SYS01ĆB09 B35/09
unassigned # 2 jog SYS01ĆB10 B35/10
unassigned # 3 jog SYS01ĆB11 B35/11
executing clamp forward jog SYS01ĆB12 B35/12
executing clamp reverse jog SYS01ĆB13 B35/13
executing ejector advance jog SYS01ĆB14 B35/14
executing ejector retract jog SYS01ĆB15 B35/15
Profile Complete 1st clamp close profile complete SYS02ĆB00 B35/16
2nd clamp close profile complete SYS02ĆB01 B35/17
3rd clamp close profile complete SYS02ĆB02 B35/18
LP close profile complete SYS02ĆB03 B35/19
1st clamp open profile complete SYS02ĆB10 B35/26
2nd clamp open profile complete SYS02ĆB11 B35/27
3rd clamp open profile complete SYS02ĆB12 B35/28
clamp open slow profile complete SYS02ĆB13 B35/29
ejector profile complete SYS02ĆB14 B35/30
Busy Status no action (outputs at zero) SYS02ĆB15 B35/31
Miscellaneous Status clamp in mold protection zone SYS03ĆB00 B35/32
mold safe SYS03ĆB01 B35/33
tonnage complete SYS03ĆB02 B35/34
clamp in openĆslow zone SYS03ĆB06 B35/38
mold open SYS03ĆB07 B35/39
ejector stopped at end of stroke SYS03ĆB08 B35/40
mold open dwell timer is timing SYS03ĆB09 B35/41
ejector forward dwell timer is timing SYS03ĆB10 B35/42
cycle complete SYS03ĆB11 B35/43
ejector fully advanced SYS03ĆB12 B35/44
ejector beyond tip advance position SYS03ĆB13 B35/45
ejector inside tip retract position SYS03ĆB14 B35/46
ejector fully retracted SYS03ĆB15 B35/47