Rockwell Automation 1771-QDC, D17716.5.87(Passport) CLAMP AND EJECT MODE - Manual (Page 76)

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-9
Table 6.J
(continued)
Operation: Function Enabled
(when = 1):
QDC Block
Addr.:
ProĆSet
Addr:
Configured
Protection from
ClampĆzone
Overrun
If a clamp close profile overruns the
mold protection zone:
0 = start LPĆclose profile
1 = stop and zero outputs
CPC03ĆB11 B37/299
If a clamp open profile overruns the
clamp open slow zone
0 = start open slow profile
1 = stop and zero outputs
OPC03ĆB11 B37/619
Additional Ejector
Configuration
start ejector profile on command from PLC
processor
(0 = start ejector profile on position during
clamp open profile)
EPC03ĆB08 B39/168
disable ejector profile
(0 = enable ejector profile)
EPC03ĆB09 B39/169
change intermediate strokes to tip strokes
(0 = all ejector strokes are full strokes)
EPC03ĆB13 B39/173
execute forward dwell after 1st advance stroke
(0 = execute forward dwell after last advance
stroke)
EPC03ĆB15 B39/175