Rockwell Automation 1771-QDC, D17716.5.87(Passport) CLAMP AND EJECT MODE - Manual (Page 69)

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-2
Table 6.A lists the tables included in this chapter along with specific
information found in each:
Table 6.A
Bit Table Summary
Type of Function: What the Table Contains: How You Implement Commands:
Table 6.B
Manual (nonĆprofiled) Command and status bits to control and monitor
manual jog, direct setĆoutput, and stop
To enable: set command bit (0 to 1)
To terminate: reset command bit (1 to 0)
Table 6.C Automatic (profiled) Command bits to control profiles To enable: toggle command bit (0 to 1 to 0).
Terminated by the QDC module automatically.
To force early termination: set stop bit (0 to 1),
or initiate another automatic function.
Table 6.D Automatic (profiled) Status and command bits to link automatic
functions during a machine cycle
Input conditions and permissives to initiate
subsequent machine movements:
(1 = enabled, 0 = disabled)
Table 6.E Automatic (profiled) Command bits to interrupt clamp movement see table
Table 6.F Automatic (profiled) Miscellaneous status bits to trigger clamp action 0 = disabled, 1 = enabled
Table 6.G Automatic (profiled) Command bits to enable/disable ejector profiles see table
Table 6.H Automatic (profiled) Miscellaneous status bits to trigger ejector
action
0 = disabled, 1 = enabled
Table 6.I --- Status bits for clamp and eject mode see table
Table 6.J --- Command bits for clamp and eject mode see table
Table 6.B
Command and Status Bits for Manual Control in Clamp and Eject Mode
To Initiate this action: Set this bit: The QDC module sets this
bit during execution:
Unassigned # 1 Jog DYC01ĆB09 SYS01ĆB09
Unassigned # 2 Jog DYC01ĆB10 SYS01ĆB010
Unassigned # 3 Jog DYC01ĆB11 SYS01ĆB11
Clamp Forward Jog DYC01ĆB12 SYS01ĆB12
Clamp Reverse Jog DYC01ĆB13 SYS01ĆB13
Ejector Advance Jog DYC01ĆB14 SYS01ĆB14
Ejector Retract Jog DYC01ĆB15 SYS01ĆB15
Direct SetĆoutput DYC01ĆB08 SYS01ĆB08
Stop DYC02ĆB15 SYS02ĆB15
Use Bit Tables