Rockwell Automation 1771-QDC, D17716.5.87(Passport) CLAMP AND EJECT MODE - Manual (Page 67)

Jog Your Machine
Chapter 5
5-8
Download Jog Configuration Block (JGC)
Utilizing the same procedure outlined in chapter 3, enter your initial inject
and screw rotate jog values in Worksheet 5-B. To download this block ,
refer to the download procedure outlined in chapter 4.
Word 1 in the Dynamic Command block (DYC01) is used to enable and
disable individual jogs. Word 1 in the System Status Block (SYS01) may
also be used to monitor the QDC module’s reaction to jog commands.
Below are two quick cross-reference tables identifying the jog enable and
status bits for the inject cylinder and screw rotate:
Table 5.C
Inject Cylinder and Screw Rotate Jog Enable Bits
Control Block Word: ProĆSet 600 Address: Description:
DYC01ĆB09
B35/393 Execute Screw Rotate Jog
DYC01ĆB10 B35/394 Execute Inject Cylinder Jog Forward
DYC01ĆB11 B35/395 Execute Inject Cylinder Jog Reverse
Table 5.D
Inject Cylinder and Screw Rotate Jog Status Bits
Status Block Word: ProĆSet 600 Address: Description:
SYS01ĆB09 B35/9 Screw Rotate Jog in Progress
SYS01ĆB10 B35/10 Inject Cylinder Jog Forward in
Progress
SYS01ĆB11 B35/11 Inject Cylinder Jog Reverse in
Progress