Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 104)

104 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Chapter 5 FactoryTalk View ME Configuration
Follow These Steps
This chapter provides two HMI application configuration options:
• Designing from a preconfigured HMI application file
• Designing from an existing HMI application file
Complete these steps to create your Logix5000 controller logic for your drives and motion application.
Design From a Preconfigured HMI Application File
If you are creating a new HMI application file for your system, use this section to configure your application file.
Using the preconfigured HMI application file is the most efficient way to create your application file. It includes
all of the displays, parameter files, and alarm setup-tags and messages required for all faceplates and devices.
If your existing HMI application file is not too extensive, it may still be more efficient to start from the
preconfigured HMI application file and copy your existing application displays, parameter files, and alarm
messages. Otherwise, follow the steps in Design From an Existing HMI Application File starting on
page 117 .
page 104
Design From a Preconfigured HMI
Application File
page 117
Design From an Existing HMI
Application File
page 138
Configure Equipment Status
Faceplate Display
page 132
Configure Goto Display Buttons on
Startup Display
• Open FactoryTalk View ME Configuration
Guide
• Restore and Open a Preconfigured HMI
Application
• Delete Unused Displays
• Delete Unused Parameter Files
• Configure Parameter Files
• Delete Unused Alarm Triggers and Tags
• Open Your Existing HMI Application File
and Add Displays
• Add Parameter Files
• Configure Parameter Files
• Import Alarm Setup File
• Delete Unused Alarm Triggers
• Import and Edit Alarm Tags
Are you creating a new
HMI application file for
your system?
No Yes
Start