Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 19)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 19
Initial System Configuration Using the DMAT Wizard Chapter 1
Review the DMAT Wizard
Once you have a general idea of the overall control architecture, relative size, and type of the drives in your
system, you can use the DMAT Wizard to create a bill of material, assemble a system drawing set, and create a
Logix Designer application project file with a preconfigured controller, network, drives, and initial system
program logic. This can be accomplished in minutes by inserting simple system and drive configuration entries
and running other system selection tools as needed.
Simple System and Drive Configuration Entries
Bill of Material Output
The initial BOM files include power and control distribution equipment, control circuit protection, operator
devices, and system drives and accessories.