Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 22)

22 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Chapter 1 Initial System Configuration Using the DMAT Wizard
FactoryTalk View Me Project File Output
The FactoryTalk View Me ConfigurationGuide folder contains two files. The FactoryTalk View Me (.apa) file
contains the basic screens and parameters needed for a DMAT Wizard application. The folder also includes a
Word document with custom instructions on how to adopt the example file to your application drive set and
prepare it to add any additional screens.
Factory Talk View ME Configuration Guide
This guide was created based on your DMAT Wizard selections and is meant to assist you in designing your
Factory Talk View ME application using the DMAT Pre-configured HMI application files. Use this document as a
supplement to the Design From a Preconfigured HMI Application File section in Chapter 5 of the Drives and Motor
Accelerator Toolkit Quick Start guide, IASIMP-QS019A-EN-P.
This document will define specific steps to help you:
Restore and Open a Preconfigured HMI Application
Delete Unused Displays
Delete Unused Parameter Files
Configure Parameter Files
Delete Unused Alarm Triggers and Tags
Configure Goto Display Buttons on Startup Display
Configure Equipment Status Faceplate Display
Design From a Preconfigured HMI Application File
Restore and Open a Preconfigured HMI Application
1. Navigate to the Panelview Plus 1000 folder
2. Double-click the PVP1000_Application.apa archive file
Delete Unused Displays
List of Required Faceplates
[ALARM]
[DIAGNOSTICS]
[INFORMATION]
CIPMotion Faceplate
K300_Faceplate
PowerFlex_753_755_Faceplate
PVP1000_Startup_Faceplate
PVP1000_StateDiagram_Faceplate
PVP1000_AlarmHistory_Faceplate
PVP1000_EquipmentStatus_Faceplate
Delete Unused Parameter Files
List of Required Parameter Files
CIPMotion_Parameter
K300_Parameter
PF_Parameter
Startup_Parameter
StateDiagram_Parameter
EquipmentStatus_Parameter