Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 51)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 51
System Layout and Wiring Chapter 3
Edit Power Drawings
1. Open your initial drive power drawing that includes the main power distribution components.
For the Widg-O-matic machine application example, the 010_K6500_460VAC_w_LIM.dwg file is
opened. Refer to the figure on
page 52 .
2. Delete drives not used in your project.
For the Widg-O-matic machine application example, only two Kinetix 6500 drives are required, so the
third drive is deleted. Refer to the shaded area in the figure on
page 52 .
3. Open all additional drive drawings and delete drives not used in your project.
For the Widg-O-matic machine application example, both the
020_K300_460VAC_Additional_Drives.dwg file and the
020_PF750_Series_460VAC_Additional_Drives.dwg file are opened and unused drives are deleted. Refer
to the figures on
page 53 and page 54 .
4. Open all controller control power drawings and edit power connections and devices as necessary.
For the Widg-O-matic machine application example, no changes to the
030_CLX_GLX_120VAC_Control_Power.dwg files were required. Refer to the figure on
page 55 .