Configure kinetix 300 drives – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 312
312
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix G
Controller, Network, and Device Configuration Without the DMAT Wizard
6.
Name the module.
For the Widg-O-matic application example, the name is Diverter_Drive.
7.
Enter the IP Address.
For the Widg-O-matic application example, the IP address is 192.168.1.35.
8.
In the Module Definition field, click Change.
The Module Definition dialog box opens.
9.
Enter major and minor revisions appropriate for your drive
hardware.
10.
Click OK to save and close the Module Definition dialog box.
11.
Click OK to save and close the New Module dialog box.
12.
Verify your device configuration and save the file.
Configure Kinetix 300 Drives
In this section you configure each Kinetix 300 drive by using MotionView OnBoard software. Follow these three
procedures to configure a single drive.
•
Connect to the Kinetix 300 Drive
•
Set Kinetix 300 Drive IP Address
•