Set kinetix 300 drive ip address – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 314
314
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix G
Controller, Network, and Device Configuration Without the DMAT Wizard
7.
Enter the drive IP Address.
The drive IP address is scrolling across the keypad display.
8.
Click Connect.
MotionView software connects to the drive. Your drive’s IP address and drive organizer appear.
9.
Click the drive IP address to display the drive identification data.
Set Kinetix 300 Drive IP Address
The drive’s IP address scrolls across the keypad display. The drive IP address must match the IP address used in
your application. Follow this procedure if you need to change the IP address of your Kinetix 300 drive. If the
address is correct then skip this section.
1.
Open MotionView software and connect to your Kinetix 300 drive.
Follow the procedure in the previous section or if the
MotionView Java application has been downloaded,
double-click the MotionView Onboard icon.
Drive
Identification
Drive
Organizer