Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 17)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 17
Chapter
1
Initial System Configuration Using the DMAT Wizard
In this chapter you use the Drives and Motion Accelerator Toolkit (DMAT) Wizard to create an initial bill of
materials, assemble a system drawing set, and create a Studio 5000 Logix Designer project file with a
preconfigured controller, network, drives and initial system program logic. In addition, you are introduced to
several Rockwell Automation system configuration tools that provide assistance in sizing your motor/drive
combinations for a variety of load, transmission, and application types.
To assist you in architecture and hardware selection, the Widg-O-matic machine application is referenced in the
selection steps. Hardware selection includes all power and control equipment to support two servo drives for the
X-Y gantry, one PowerFlex drive for the conveyor, and one Kinetix 300 drive for the packaging diverter.
Widg-O-matic Machine Application Example
755
0 0 3 0 0
Conveyor
Y-Servo
X-Servo
X-Y Gantry
Kinetix 6500
Drives
Diverter
Kinetix 300
Drive
PowerFlex 753
Drive
Se
rvo
M
oto
r D
riv
en
Ele
ctr
ic C
yli
nd
er
Ind
uct
ion
Mo
tor
Assembly
Packaging