Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 265)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 265
Assemble Project Drawing Set Without the DMAT Wizard Appendix F
For the Widg-O-matic machine application example, the Ethernet
communication drawing was copied to accommodate all of the
drives and HMI terminals in the system.
Select System Layout Drawings
1. Navigate to the desired (DWG, DXF, or PDF) file type folder on the toolkit DVD and select Layouts
Section.
2. Double-click the 01_Enclosure_Layouts folder and
open either the Large (60”x60”x12”) or Small
(60”x36”x12”) enclosure folder based on your
system enclosure needs.
For the Widg-O-matic machine application example, the Small enclosure folder was selected.
3. Right-click the 140_
xx_Enclosure_Layout.xxx drawing required for your application and choose Copy.