Ch2 - bill of materials completion, Before you begin, What you need – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 37: Chapter 2, Bill of materials completion, Before you begin what you need, Chapter
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
37
Chapter
2
Bill of Materials Completion
In this chapter you use Rockwell Automation ProposalWorks software to complete the drives and motion system
bill of materials that the DMAT Wizard created.
If you chose not to use the DMAT Wizard, follow the procedures in
to assemble the initial BOM
ProposalWorks file before executing the following steps in this chapter. If you do not have ProposalWorks
software, you may use the Microsoft Excel file that the DMAT Wizard provides as a starting point in creating a
bill of materials with the help of your local Allen-Bradley distributor.
Before You Begin
•
Complete the initial system configuration using the DMAT Wizard (refer to
•
Assemble the initial BOM using ProposalWorks software (refer to
)
What You Need
•
The Drives and Motion Accelerator Toolkit DVD, publication
. For a copy of the DVD,
contact your local Rockwell Automation distributor or sales representative
•
ProposalWorks software, version 7.5 or later, or Microsoft Office Excel 2010
Download ProposalWorks software fr
or ask your
local Allen-Bradley distributor for the Product Selection Toolbox DVD.
•
The user manual for your Drives and Motion hardware. Refer to
for
publication numbers.