Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 144)

144 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Chapter 5 FactoryTalk View ME Configuration
Configure Equipment Status Faceplate for Energy Monitoring
The Equipment Status Faceplate for Energy display provides a summary of the energy status of the devices in
your system and also provides another launch site for your individual device faceplates.
This equipment status display works in the same manner as the standard Equipment Status faceplate described in
the previous section, however, it displays only energy related data.
Add the Equipment Status Faceplate for Energy Display
1. Right-click Displays within the Graphics folder and select Add Component Into Application.
2. Navigate to the 04_Equipment_Status folder within the toolkit’s files folder.
Your personal computer’s harddrive path is C:\Program Files\RA_Simplification\DMAT\B-Files\
5-HMI\ME\HMI Modules\04_Equipment_Status.
3. Select the PVP1000_EquipmentStatus_Faceplate_Energy.gfx
4. Click Open.
Add the ME_Equipment_Parameter File
1. Right-click Parameters within the Graphics folder and select Add Component Into Application.
2. Navigate to the 04_Equipment_Status folder within the toolkit’s files folder.
Your personal computer’s harddrive path is C:\Program Files\RA_Simplification\DMAT\B-Files\
5-HMI\ME\HMI Modules\04_Equipment_Status.
3. Select the Energy_EquipmentStatus_Parameter.par file.
4. Click Open.
5. Verify the Energy_EquipmentStatus_Parameter file appears under Parameters.
IMPORTANT You must use the device module routines with energy support to support the equipment status faceplate for energy.