Metrohm tiamo 2.3 Manual - Manual (Page 1049)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1033
Range 0 ... 100 Pixels
Default value 0 Pixels
5.6.4.13 MEAS Spec
5.6.4.13.1 MEAS Spec - Overview
Dialog window: Method ▶ MEAS Spec ▶ Properties... ▶ MEAS Spec - 'Command
name'
Command for the Measurement of the sample spectrum.
Instruments
This command can be executed with the following device:
Spectrometer: Avantes
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Spec are configured on the fol-
lowing 3 tabs:
￭ General/Hardware
Parameters for device.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Definition of evaluation results for the sample spectrum.
Command variables
The following command variables are generated in the method run by the
command MEAS Spec and can be used in formulas under the designa-
tion 'Command name.Variable designation':
Designation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL Total duration for the processing of the command in s
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) = Com-
mand has never ended