Metrohm tiamo 2.3 Manual - Manual (Page 1052)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1036 ￭￭￭￭￭￭￭￭ tiamo 2.3
Range 0 ... 100 Pixels
Default value 0 Pixels
5.6.4.13.4 MEAS Spec - Evaluations
Tab: Method ▶ MEAS Spec ▶ Properties... ▶ Evaluations
Command name
Name of the command.
Input 25 characters
The following additional methods for evaluation of measurement curves
can be activated and defined on this tab.
[New]
Open the dialog window Evaluation window # for entering the start
and end wavelengths (see Chapter 5.6.4.13.5, page 1036).
[Properties]
Open the dialog window Evaluation window # for editing the start and
end wavelengths selected in the table (see Chapter 5.6.4.13.5, page
1036).
[Delete]
Delete the selected line.
5.6.4.13.5 MEAS Spec - Evaluation window
Dialog window: Method ▶ MEAS Spec ▶ Properties... ▶ Evaluations ▶ [New]/[Prop-
erties] ▶ Evaluation window #
Start wavelength
Lower limit of the evaluation range.
Range 100.0 ... 2000.0 nm
Default value 400.0 nm
End wavelength
Upper limit of the evaluation range.
Range 100.0 ... 2000.0 nm
Default value 1000.0 nm