Metrohm tiamo 2.3 Manual - Manual (Page 1347)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1331
[Delete]
Deletes the selected conductivity standard.
[Copy]
Copies the selected conductivity standard, which is saved under the name
Copy of.....
6.3.3.4.2 Edit conductivity standard
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Conductivity stand-
ards ▶ Conductivity standards ▶ Edit conductivity standard
With [New] or [Properties] in the dialog window Conductivity stand-
ards, the dialog window Edit conductivity standard opens for entering
a new conductivity standard or for editing an existing conductivity stand-
ard.
Name
Name of the conductivity standard.
Input 25 characters
Comment
Comment on the conductivity standard.
Input 1000 characters
Measured observational pairs
Table with the value pairs for Temperature and Conductivity, which
were determined for the conductivity standard. The table cannot be edi-
ted, but with a click on the column title the temperature can be sorted
according to either increasing or decreasing sequence.
[New]
Creation of a new value pair. The window Edit value pair opens, in
which a new value pair can be entered (see Chapter 6.3.3.4.3, page
1332).
[Edit]
Edits the selected value pair. The window Edit value pair opens, in
which the value pair can be edited (see Chapter 6.3.3.4.3, page 1332).
[Delete]
Deletes the selected value pair.