Metrohm tiamo 2.3 Manual - Manual (Page 1139)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1123
5.6.5.11 CAL MEAS Opt
5.6.5.11.1 CAL MEAS Opt - Overview
Dialog window: Method ▶ CAL MEAS Opt ▶ Properties... ▶ CAL MEAS Opt - 'Com-
mand name'
Command for Measuring standard solutions for the calibration of
colorimetric sensors, which is used together with the command CAL
LOOP Opt.
Instruments
This command can be executed with the following devices:
Spectrometer: Avantes
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the command CAL MEAS Opt are configured on the
following 2 tabs:
￭ General/Hardware
Selection of device type and colorimetric sensor.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Command variables
The following command variables are generated in the method run by the
command CAL MEAS Opt and can be used in formulas under the desig-
nation 'Command name.Variable designation':
Designa-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL Total duration for the processing of the command in s
.EME End measured value (measured value after processing of
the command) in the unit of the measured value