Metrohm tiamo 2.3 Manual - Manual (Page 336)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
320 ￭￭￭￭￭￭￭￭ tiamo 2.3
￭ Statistics
Modification of statistics data.
The tab Statistics will only be shown when the last determination
(and only this one) is selected from a set of determinations which,
because of the statistics defined in the method, belong together.
￭ Curve evaluation
Manual modification of the curve evaluation.
The tab Curve evaluation is only shown when a single determination
is selected that contains curves that can be evaluated.
4.5.2.6.4.2 Modifications - Variables
Tab: Database ▶ Determination overview ▶ Determinations ▶ Reproc-
ess... ▶ Reprocessing ▶ Modifications ▶ Variables
On the tab Variables the variables used in the determination can be
modified.
Variable table
The variable table shows those variables used that are present in all the
selected determinations and cannot be edited directly. With a click on the
column title (columns Variable, Value) the table can be sorted according
to the selected column in increasing or decreasing order.
Variable
Shows the name of the variable. This shows the method variables
(MV.'Name') defined in the START command, the common variables
(CV.'Name') used in calculation and other commands as well as the com-
mand variables 'Name'.TITER, 'Name'.CONC, 'Name'.SLO, 'Na-
me'.ENP and 'Name'.BLV.
Value
Display of the variable value. If a fixed value is defined for a variable, the
value will be presented in italics.
[Modify]
Open the dialog window Modify variable to modify the value of an
existing variable.
Note
If a variable is modified, then with [Recalculate] all the selected deter-
minations will be recalculated with the new value. If one variable is not
modified then when several determinations are recalculated the original
value of the variable will be used (i.e. variables with the same name but
different values will not be overwritten until they are deliberately modi-
fied).