Metrohm tiamo 2.3 Manual - Manual (Page 446)

5.5 Tracks ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
430 ￭￭￭￭￭￭￭￭ tiamo 2.3
5.5.2.2 Normal track
Subwindow: Method
A normal track is a track that can be created manually by the user with
Paste
▶ New track... ▶ Normal track or with the icon . It starts with
a start command (see Chapter 5.6.2.3, page 449) and finishes with an
end command (see Chapter 5.6.2.8, page 454).
Normal tracks can be called up with the command CALL and entering the
corresponding name. Branching and parallel processes can be implemen-
ted this way. A distinction is made between the following two cases when
calling up normal tracks:
￭ Sequential running normal track
If the Return immediately check box in the (see Chapter 5.6.2.3,
page 449) command is deactivated, then all of the commands of this
track will be executed in sequence. Afterwards, the track sends an
acknowledgement to the (see Chapter 5.6.10.3, page 1275) command
that did the calling up, and the run is continued there.