Metrohm tiamo 2.3 Manual - Manual (Page 391)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.3 ￭￭￭￭￭￭￭￭ 375
Column 2: Varia-
ble Column 3 Column 4 Column 5 Column 6
VAR VAR, 'empty', 3
Table 42 Command DOS pH
Column 2: Varia-
ble Column 3 Column 4 Column 5 Column 6
MR MR.MRT, mL/min,
4 MR.MRS, mL/min,
4 MR.MRC, 'empty',
3
Table 43 Command DOS U
Column 2: Varia-
ble Column 3 Column 4 Column 5 Column 6
MR MR.MRT, mL/min,
4 MR.MRS, mL/min,
4 MR.MRC, 'empty',
3
4.7.4 Results - Calculation #
Tab: Database ▶ Results ▶ Command name
For each calculation command the results and (if existent and desired) the
corresponding statistical evaluations are displayed on a separate tab Cal-
culation_#. The sequence of the shown results corresponds to that
defined in the calculation command. The display of the statistical evalua-
tions can be selected in the dialog window Properties result window
For every single result a maximum of the following information is dis-
played:
Result "Result name"
Result "Result name"
Display of the result with variable name.
Note
Only the last results having been calculated will be shown. For example,
if there are several commands that generate a result with the same
name, then the corresponding result data will be shown only for that
command that was the last to calculate the result. Nothing will be
shown for the other commands.
"Result"
Shows the result name and result value with the defined number of deci-
mal places and units.