Metrohm tiamo 2.3 Manual - Manual (Page 1053)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1037
5.6.4.14 MEAS Opt
5.6.4.14.1 MEAS Opt - Overview
Dialog window: Method ▶ MEAS Opt ▶ Properties.. ▶ MEAS Opt - 'Command
name'
Command for absorbance measurements.
Instruments
This command can be executed with the following devices:
Spectrometer: Avantes
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Opt are configured on the fol-
lowing 3 tabs:
￭ General/Hardware
Parameters for device.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Definition of evaluation results for absorbance measurements.
Command variables
The following command variables are generated in the method run by the
command MEAS Opt and can be used in formulas under the designation
'Command name.Variable designation':
Designation Description
.BP{#}.[MEA] Measured value for the break point (1…9) in the unit
of the measured value
.BP{#}.CNT Intensity for the break point x (1…9) in counts
.BP{#}.TEM 1) Temperature for the break point # (1…9) in °C
.BP{#}.TIM Time for the break point # (1…9) in s
.BP{#}.TRN Transmission for the break point x (1…9) in %